Daniel Pisarski

Some users have a set of 4 modems for Solo Connect, which actually have two total serial numbers between the set of 4 (two modems with one serial, and two modems with another).Example modem label, ...

Solo PRO SDI, when using SDI input, now supports 4 audio channels as of firmware version 10.6.5.  However, the HDMI input hardware does not support 4 audio channels.  So while you can configure you...

Solo PRO Version 10.6.5.C3693.G4aec46c1c is now available.  This is a minor patch on top of Solo PRO 10.6.4 with a few important fixes: Support revision 2 video cards (HDMI and SDI).  Please note t...

Newly added to Solo Portal, you can now set your Solo PRO unit to a third latency option, 800 milliseconds. This is in addition to the 1 second ("Low Delay Mode" in previous terminology) and 5 seco...

Solo PRO SDI now supports up to 4 audio channels, when input via SDI.  Output was specifically tested with SRT output.  Below are some highlights about using this new feature.Enabling 4 Audio Suppo...

When using Solo (on firmware 7.1.0.C16178.G054f064a6) or Solo PRO, here are the steps to setup an SRT destination.  SRT requires the use of LRT, and is sent from the LiveU cloud to the final destin...

Solo PRO Version 10.6.4.C3685.G8c2439398 is now available.  This version includes two important fixes: An issue would cause earlier 10.6.x versions to sometimes detect HDMI input audio as the wron...

Below are release notes for the latest firmware for LiveU Solo and LiveU Solo PRO: LiveU Solo 7.2.0.C16198.G33f1dd284 Huawei -325 modem support - the Huawei modem must be on latest firmware Resolv...

Firmware 7.2.0.C16191.G57870b290 Available for: LiveU Solo HDMI LiveU Solo SDI LiveU Solo Plus Includes the following features and fixes: Fix for the "USB Hub Overload" issue seen on Solo Plus w...

  1. Make sure the unit is powered down. 2. Insert a paperclip into the Factory Reset pinhole. This can be found right below the HDMI port on the original Solo model or next to the power input on t...